Table of Contents
Advertisement
Menu list
Problem
The display is in a language I
cannot read.
I cannot register a handset to a
hub.
I cannot remember the hub PIN. R Change the hub PIN using the following method.
Battery recharge
Problem
The handset beeps and/or
blinks.
I fully charged the batteries, but
–
still blinks,
– the operating time seems to
be shorter.
Making/answering calls, intercom
Problem
is displayed.
Noise is heard, sound cuts in
and out.
Sound quality seems to be
getting worse.
Helpline Tel. No.: U.K. 0330 3331112 Ireland 01 4475228
HNH100E_(en_en)_0421_ver.051.pdf
Cause/solution
R Change the display language (page 14).
R The maximum number of handsets (6) is already
registered to the hub. Cancel unused handset
registrations from the hub (page 31).
R You entered the wrong hub PIN. If you forget your PIN,
see "I cannot remember the hub PIN." (page 49).
1
M
N#132
2
*7000
3
Enter the new 4-digit hub PIN. a MOKN
4
MbN: "Yes" a MOKN a MeN
Cause/solution
R Battery charge is low. Fully charge the batteries (page 11).
R Clean the battery ends (
with a dry cloth and charge again.
R It is time to replace the batteries (page 11).
Cause/solution
R The handset is too far from the hub. Move closer.
R The hub's AC adaptor is not properly connected.
Reconnect AC adaptor to the hub.
R The handset is not registered to the hub. Register it
(page 31).
R You are using the handset or hub in an area with high
electrical interference. Re-position the hub and use the
handset away from sources of interference.
R Move closer to the hub.
R If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the hub and the
telephone line jack. Contact your DSL/ADSL provider for
details.
R You have registered a handset that is not recommended
(page 4). The clearest sound quality is only possible by
registering the recommended handset.
49
Useful Information
,
) and the charge contacts
2015/04/22
49
19:08:48
Advertisement
Table of Contents
