Panasonic KX-tg2248CS Operating Instructions Manual page 59

✿✤✦✪✤✧Z✮_✩.❇m 5✬
Problem
The unit does not announce
the displayed caller's name.
The unit does not announce
the displayed caller's name
properly.
Previously programmed
information is erased.
" Recharge battery " is
displayed, " " flashes or
the unit beeps intermittently.
You charged the battery fully,
but " Recharge battery " is
still displayed and/or "
continues to flash.
The IN USE/CHARGE
indicator light does not go out
after the battery has been
charged.
] ]
Cause & Remedy
• The handset and base unit ringer volumes are
OFF (p. 18).
• The Talking Call Display feature is OFF
(p. 16).
• Name pronunciation may vary.
• The unit will announce each letter of
abbreviations, such as Co., Inc., etc.
• Call Display service supports names of up to
15 letters. If the caller's name has more than
15 letters, the name will not be announced
correctly.
• If a power failure occurs, programmed
information may be erased. Reprogram if
necessary.
• Charge the battery fully (p. 9).
• Clean the charge contacts and charge again
(p. 10).
" • Install a new battery (p. 8).
• This is normal.
_
Troubleshooting
59