Altering The Anti-Crease Function - Miele T 8861 WP Edition 111 Operating Instructions Manual

Altering the Anti-crease
function
Helps prevent creasing if laundry is
not normally removed immediately
after the end of a programme.
Anti-crease
– is set at the factory, can be
shortened or switched off
completely.
– can be used for all programmes,
except Woollens.
– should always be switched on.
Follow steps (A,B,C ...) to
programme and store in memory.
Before you begin, first ensure that:
– The dryer is switched off.
– The door is closed.
A Press the Start/Stop button and keep
it pressed in whilst carrying out steps
B-C.
B Switch the dryer on.
Wait until the indicator light for the
Start/Stop button lights up constantly. . .
C . . . and then release the Start/Stop
button.
D Press the Gentle tumble button
twice.
– The Gentle tumble indicator light will
briefly flash three times.
Programmable functions
The option selected will be displayed
by a number which will alternate with
P.
0 Anti-crease deactivated
I 1 hour Anti-crease
(the Automatic plus indicator light will
also flash once)
2 Factory default setting; 2 hours
Anti-crease
(the Automatic plus indicator light will
also flash twice)
E Pressing the Start/Stop button
switches from one number to the
other.
F Switch the dryer off.
The setting you have selected is now
stored in memory. You can alter the
settings again at any time.
Check
^ Repeat steps A to D.
^ Switch the dryer off after step D.
55