Table of Contents
Advertisement
Installation and connection
With niche heights of:
– 830-840 mm, longer screw feet* are
required.
– 870-885 mm / 915-930 mm, one or
two raising kits* are required.
* accessory available to order
N.B. If you wish to push the tumble
dryer under a worktop and there is
space to do this without removing the
lid, the building-under kit is not
necessary. Otherwise the
building-under kit is essential.
Levelling the machine
The machine must be perfectly level to
ensure safe and proper operation.
44
^ The screw feet can be adjusted to
compensate for any unevenness in
the floor.
,
The gap between the tumble
dryer and the floor must not be
minimized by a plinth facing,
high-piled carpets etc., as this
would prevent sufficient ventilation.
Before moving the tumble dryer
again (e.g. when moving houses)
After each use a small quantity of
condensed water will collect in the area
around the pump. This water can run
out if the tumble dryer is tipped up
when it is being moved. It is a good
idea to run the Cool air programme for
approximately 1 minute before moving
it. Any remaining condensed water will
then be fed into the condensed water
container or out through the drain hose.
Washer-dryer stack
The tumble dryer can also be
combined with a Miele washing
machine in a washer-dryer stack. The
appropriate "WTV" stacking kit* to
match your dryer is required.
* accessory available to order
,
Stacking kits must only be
installed by a suitably qualified fitter.
Hide quick links:
Advertisement
Table of Contents
