Ground Ring Assembly (Cwx00560) - Panasonic YC-300BP2YAF Operating Instructions Manual

3.5.2 Ground ring assembly (CWX00560)

In case of an insufficient arc start, you can install this
ground ring to improve it.
How to install the ground ring assembly
As for its initial installation, consult with our CS
center.
(An installation error may cause damage to the
torch, or make it impossible to improve an insuf-
ficient arc start.)
3.5.3.Extension cable (Made to order)

Use an extension cable when the welding torch
cable is not long enough. (It is connected between
the welding torch and this product.)
* It is not possible to connect extension cables
each other because of their structure. (Use one
extension cable only.
Note
As the output terminal of this product employs a fingertip joint, the extension cable, which employs a bolt-fixing termi-
nal, cannot be connected to this product without using a terminal adapter.
Also, as the torch switch outlet of the extension cable is different in type from the outlet of this product, it cannot be
connected to this product without using a control cable assembly.

When connecting the special torch to an extension
cable, remove the replacement cable clamp
(Fig.1) attached to the welding machine side of the
special torch. (Remove the rubber cover of the
Note
The torch connection side of the extension cable employs a screw connection. As the special torch with the replace-
ment cable clamp removed also employs a screw connection, it can be connected with the extension cable
Applicable torches
YT-15TS1
YT-15TS1C1
YT-20TS1TAG*
Air-
YT-20TS1TAH*
cooling
YT-20TS1
YT-20TS1C1
YT-208T
YT-208TC1
YT-30TSW1TAG*
YT-30TSW1TAH*
YT-30TSW1
Water-
YT-30TSW1C1
cooling
YT-208TW
YT-208TWC1
YT-308TW
YT-308TWC1
*1: Special torch
*2: Refer to the "Example of extension cable connection" on the next page.
OMCTT5639E09
Welding torch
Ground ring ass'y
(CWX00560)
5 m
TWU15125
1
1
TWU20131
1
1
TWU30132
(For details, see the instruction manual supplied with the
ground ring assembly.)
nozzle

To use an extension cable, you are required to
purchase the terminal adapter (CWC00180) and
the control cable assembly (TWX00018) sepa-
rately. (Quantity: one each) (See Fig.2, Fig.3)
replacement cable clamp, and the screw appears.
Remove that screw, and the replacement cable
clamp comes off.)
Extension cable length
10 m
TWU15126
TWU20132
TWU30133
Installation
(Lead wire)
(Resistor)
Connect either to welder
case or base metal.
15 m
TWU15127
TWU20133
2
TWU30134*
15