Peripheral Equipment (Optional Items); Tig Welding Torch - Panasonic YC-300BP2YAF Operating Instructions Manual

Installation

3.5 Peripheral equipment (Optional items)

3.5.1 TIG Welding torch

(1) Special torch (Fingertip joint)
(2) Type-1.8 TIG welding torch
You are required to purchase the torch connection
adapter separately.
TIG welding torch
(Non-fingertip joint)
YT-08TS1, YT-088T
YT-12TS1, TP1, YT-128T(P)
YT-15TS1, TP1, YT-158T(P)
YT-20TS1, YT-208T
YT-20TSW1
YT-30TSW1,TPW1
YT-208TW,TPW
YT-308TW,TPW
(To output terminal)
Welder side
(To gas outlet clamp）
Remove the torch cable clamp, and connect it to the torch
side as shown in the above figure. (The welder side uses a
fingertip joint, and the torch side uses a screw-type clamp.)
<Fig. 1 Replacement cable clamp>
(3) When using any TIG welding torch other than those
described in the above items (1) and (2):
You are required to purchase the terminal adapter
(CWC00180: See the figure shown below) and the
Welder side:
Fingertip joint
(P3550-2)
<Fig.3> Terminal adaptor (CWC0018)
14
Air-cooling 200A torch
YT-20TS1TAG (4 m)
YT-20TS1TAH (8 m)
YX-151AJ1J1
YX-201AJ1
YX-301A J1
Shown below is the case of the air-cooling torch.
(As for the water-cooling torch, a hose and clamp for
return water shall be used, and connected to the
cooling-water equipment.)
Cabtire cable: 38 mm
300
Water-cooling 300A torch
Torch connection adapter
Product number
[Replacement cable clamp]TJM00046
[Control cable assembly]TWX00018
[Replacement cable clamp]TJM00038
[Control cable assembly]TWX00018
[Replacement cable clamp]TJM00041
[Control cable assembly]TWX00018
Torch side
Welder side
<Fig.2 Control cable assembly (TWX00018)>
control cable assembly (TWX00018: See the upper
right figure) separately. (Quantity: one each)
Torch side:
2
Crimp terminal
(For Ｍ8, (φ8.4), Width: 22 mm)
After its connection to the torch,
make sure to insulate it by tape,
etc.
YT-30TSW1TAG (4 m)
YT-30TSW1TAH (8 m)
Descriptions (See also Fig.1)
Toch side
OMCTT5639E09