Panasonic YC-300BZ3YHD Operating Instructions Manual page 27

Terminal
Terminal #
name
4
Current
detect
O
5
U
T
P
U
T
6
Pulse detect
7
OMCTT5621E18
Jig terminal block
7 6
5
Functions
• Output current (Initial current, welding current
including pulse current and base current, and cra-
ter current) flows between those terminals.
• The terminals are connected with normally open
contact at the relay on the PC board.
• The terminals are closed when the output current
is detected.
Application:
Use it to start a device at the jig side, such as robot,
synchronously with the current detection.
• Output current (Initial current, welding current
including pulse current and base current, and cra-
ter current) flows between those terminals.
• The terminals are connected with normally open
contact at the photo MOS relay on the PC board.
• The terminals are closed in synchronization with
the pulse output current only.
Jumper
2
4 3 1
Contact capacity (Resistive load):
* Never operate over the capacity.
Contact capacity (Peak AC and DC)
* Never operate over the capacity.
Connection
Note
DC: 24V, 1A
AC: 125V, 0.3A
Load voltage: 350 V
Load current: 0.13 A
27