Off Timer - Sanyo PDP42H2W Owner's Manual

With the Off timer function, the Plasma Monitor can be set to turned off automatically after 30, 60, 90 or 120 minutes.
SET THE OFF TIMER
1
Pressing the OFF TIMER button on the Remote Control Unit
until the desired minutes is displayed.

Off timer

30
2
When remaining time reaches zero, the message "Off timer:
Power off" appears for 10 seconds, then the Plasma Monitor will
shut off; goes into standby mode.
Check the remaining time
Press the OFF TIMER button once to check the remaining time of Off
timer set. The remaining time will be displayed for a few seconds.
When switching input modes, the remaining time is displayed below
the selected input mode.
Cancel the Off timer
Press the OFF TIMER button until the time "0" is displayed.
NOTE:
While the Off timer function is set, the OFF TIMER indicator lights red.
OFF TIMER
30 60 90 120
INPUT
VIDEO
COMPONENT
PC/DVI-D
OFF TIMER
WIDE
PICTURE MOVE UP
0
OK
STATUS MOVE DOWN MENU
SURROUND
AUTO PC
Off Timer Indications
Off timer
58 Min.
Off timer
0 Min.
BASIC OPERATION
ON-OFF
VOLUME
OFF TIMER
button
MUTE
POWER
AV 1
58 Min.
19