Sanyo PDP42H2W Owner's Manual page 10

PREPARATION
3
Install the soft tape on the side of each speaker to contact the Plasma Monitor and fix the speakers to the Plasma
monitor with the small screws.
Speaker
4 Connect the Speakers and the Plasma Monitor with the speaker cables.
Speaker Cables
NOTE :
Take off the outer shield of the cable end and twist the
inside wires before connecting to the Plasma Monitor as
above.
CAUTION IN HANDLING THE SPEAKERS
● Do not input over specified power otherwise damaging the Speakers and fire hazard may result.
● Do not locate under direct sun light or moistened place, the Speakers may be damaged.
● The Speakers are not provided with internal magnetic shield. Take a distance from equipment or appliances that
are influenced by magnetic field.
● For cleaning, please wipe lightly with a soft cloth. For heavy stains, carefully wipe with a cloth diluted neutral
detergent and finish off with a dry cloth.
● Wiping with a cloth containing oil or thinner may damage the fine surface. If using a chemically treated cloth,
please follow the instructions carefully.
● Do not spray volatile substances or any liquid, nor put rubber, adhesive tape, or vinyl object on the unit for long
periods of time. It may cause permanent damage to the unit or the fine surface.
10
Soft Tape
Take off the shield
of the cable end.
Twist the wires.
Black
(-)
Small Screws
(2pcs)
Speaker
Small Screws
(2pcs)
Red (+)
Black (-)
NOTE :
Red
Hold the terminal tab until the twisted
(+)
wires is fully inserted into the hole.