Dcm2.2; Dcm2.2 (M15737A001) Highlights; Dcm2.2 Led Functions - GILBARCO VEEDER-ROOT Encore 700 S Start-Up And Service Manual

DCM2.2

DCM2.2

DCM2.2 (M15737A001) Highlights

Figure 4-15: DCM2.2 Board
J3 HomePlug
New Location
JP12 - New SmartCRIND
Jumper

DCM2.2 LED Functions

The following table lists the LED functions of DCM2.2:
LED Functions
D1 Power Good
D23 HP UP
D20 SSoM REG
D19 SSoM USB
D13 ETH LINK ACT
D18 HomePlug
D21 LED "Router Enable" If "ON Green", SSoM is installed and running, does not mean it is configured
D5 and D6
D4 and D7
D2
D14
MDE-4902E Encore® 700 S Start-up and Service Manual · February 2018
JP5 - New Jumper for VLAN
(UX410)
New - These ports become dedicated for specific devices
when VLAN Jumper is installed (printed on the PCB)
VDC 24V is "ON" = Good
HomePlug jumper is installed "ON" = Good, CPU is running, but does not indicate
that there is a connection to the BRCM2.X in back room. Internal CCP status only.
Registered to the cloud
USB port activity LED
Same as DCM2.1 - HomePlug jumper is OFF, P304 direct ethernet connection active
HomePlug is active and connected to BRCM2 (2.1 or 2.2)
properly. If LED is "OFF", the assembly must be replaced.
New labeling - NON-OLC, monitors P300 pins 1 and 3
OLC (new labeling), monitors either P300 pins 4 and 5 or P333 pins 3 and 4
depending on the two-wire configuration
Reversed two-wire
Reversed two-wire
JP6 - New Jumper for Pump
Current Loop Selection
Service
P333 - New Connector for
Dedicated High-Speed
Page 4-19