Editing The Setup - GE Multilin EPM 2000 Series Instruction Manual

2.2.1. Editing the Setup

First, take a look at the Keypad Operations
below.
To enter "SET" and change a Setting value, the sequence (shown below) is: 1, 2, 3, 4. Along
the way, the following must be observed:
•
The Password Code must be entered to change the Setup. The code offered will read
"0000". Edit ( , ) the blinking Digit to achieve "1000". Press
digit, to keep moving towards the "RUN" page. The Meter accepts each digit entered, but
masks it with "0000" so someone watching doesn't steal the password.
After changing the desired Setup values (Step 4), the sequence to get back to the RMS page
is: 5, 6, 7, 8.
•
Exiting Setup requires you to Save the settings (Step 6). "SAVE Y", press
To Discard the changes, toggle Up
•
Going forward from 7 (RUN) to 8 (PROG) does not require any Code. You go
straight through.
Entering into the setup on power up
•
1.1.1 During power on, press the Turbo key continuously for 2sec and displays SET.
1.1.2 Press the
1.1.3 Follow the above procedure.
EPM 2000 v03.01.01.00
Main
Menu
2
RUN
7
To Run Mode
CLR
3
SET
Save
Y
6
GE Multilin
Table. Locate the Shaded, Bold display pages
or Down
key. Displays the desired value to be changed.
Code Entry
Password
Code
Code
Y
1000
Setup
Name Value
5
Figure 2-2a: Entering and Exiting Setup
Sub Meters
when done with each
to get "SAVE N" before pressing .
Legend Use orkeys
Use orkeys
Use key only
1
To Prog Mode
8
New
4
Value
Enter the New Value.
.
,
Prog
RMS
21