Sealey WK025 Instructions

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH
IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE
THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
 Follow all workshop Health & Safety rules, regulations and conditions when using tool.
 WARNING! Disconnect from air supply before changing cutting blade or servicing.
 Maintain tool in good condition and replace any damaged or worn parts. Use genuine parts only.
Unauthorised parts may be dangerous and will invalidate the warranty.
 WARNING! Check correct air pressure is maintained and not exceeded. We recommend 90psi.
 Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each use and ensure
that all connections are secure.
 WARNING! Before each use check cutting blade is secure and that the blade is not worn or damaged. If
damaged replace immediately.
 Ensure replacement blades are not damaged in any way such as cracks etc.
 DO NOT over tighten a blade and never tamper with a blade in order to adapt it to a different size holder.
 Always use the correct blade suitable for the material being cut.
 WARNING! Always wear approved hand and eye or face protection when operating the tool.
 Use breathing protection in accordance with COSHH regulations if fumes or dust pose a hazard.
 Wear ear defenders and gloves if necessary.
 Keep hands and body clear of the workpiece when operating the tool.
 Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
 Keep children and non essential persons away from the working area.
 Avoid subjecting blade to excessive strain, always ease blade down against workpiece (a harsh impact
could break the blade). Do not use force in order to cut workpiece. Maintain a controlled progression.
 DO NOT hold the workpiece by hand. Use a clamp, vice or other adequate holding device to secure the workpiece.
 DO NOT use the tool for a task it is not designed to perform.
 WARNING! DO NOT use tool if damaged or faulty. Contact your local service agent.
 DO NOT use tool unless you have been instructed in its use by a qualified person.
 DO NOT position your body in line with the blade whilst cutting.
 DO NOT carry the tool by the air hose, or yank the hose from the air supply.
 DO NOT direct air from the air hose at yourself or others.
 WARNING! DO NOT cut any materials containing asbestos.
 DO NOT switch the tool on whilst the blade is in contact with the workpiece.
 DO NOT allow workpiece to overheat.
 DO NOT use tool where there are flammable liquids, solids or gases such as paint solvents, including waste
wiping or cleaning rags etc. as any sparks generated may be dangerous.
 DO NOT touch the workpiece close to the cut surface as it may be hot. Allow to cool. The workpiece
may also be very sharp.
 DO NOT operate tool if you are tired or under the influence of alcohol, drugs or intoxicating medication.
 When not in use disconnect from air supply and store in a safe, dry, childproof location.
INSTRUCTIONS FOR:
AIR KNIFE
MODEL No:
Original Language Version
WK025
WK025 Issue: 2 - 11/11/09