Viewing Poe Status; Understanding And Modifying The Default Settings; Poe Class Detection - Nokia Alcatel-Lucent OmniSwitch 6360 Hardware User's Manual

Managing Power over Ethernet (PoE)

Viewing PoE Status

To view current PoE status and settings, use the
-> show lanpower slot 1/1
Port Maximum(mW) Actual Used(mW)
----+-----------+---------------+-----------+---------+--------+-------+----------
1 60000
2 60000
3 60000
4 60000
5 30000
6 30000
7 30000
8 30000
ChassisId 1 Slot 1 Max Watts 120
0 Watts Total Power Budget Used
120 Watts Total Power Budget Available
1 Power Supplies Available
'*' appending port maxpower indicates 4pair port operating in 2pair mode

Understanding and Modifying the Default Settings

The sections below provide information on each of the key components within the Power over Ethernet
software. They include information on PoE-related CLI commands. For detailed information on PoE-
related commands, refer to the OmniSwitch CLI Reference Guide.

PoE Class Detection

Powered devices can be classified into different classes as shown in the table below. Class detection
allows for automatic maximum power adjustment based on the power class detected. This will prevent the
switch from delivering more than the maximum power allowed based on a device's class.
During class detection, the switch will allocate the maximum amount of power allowed based on the class
detected. Once powered, if the device uses less than the maximum, the remaining power will be made
available for other devices.
Standard
IEEE 802.3af
802.3at
802.3bt
OmniSwitch 6360 Hardware Users Guide
Status
0 Powered Off
0 Powered Off
0 Powered Off
0 Powered Off
0 Powered Off
0 Powered Off
0 Powered Off
0 Powered Off
Class Type
0 1
1 1
2 1
3 1
4 2
5 3
6 3
7 4
8 4
April 2021
show lanpower slot command:
Priority On/Off
Low OFF
Low OFF
Low OFF
Low OFF
Low OFF
Low OFF
Low OFF
Low OFF
Pairs
2
2
2
2
2
4
4
4
4
Power over Ethernet Budget
Class Type
.
.
.
.
.
.
.
.
Power at Port
(Watts)
15.4
4.0
7.0
15.4
30
45
60
75
90-99
page 4-5