Sealey RE55.V6 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
Familiarise yourself with the application, limitations and hazards of the rack.
9
Maintain the rack in good condition (use authorised replacement parts).
9
Keep the rack clean for best and safest performance.
9
Locate the rack in a suitable work area.
9
WARNING! Use the rack on level and solid ground, preferably concrete.
‰
DO NOT overload the rack.
8
DO NOT climb on the rack.
8
DO NOT use the rack for any purpose other than for which it is designed.
8
DO NOT use the rack if any parts are damaged or missing as this may cause failure and/or personal injury.
8
Keep the work area clean, uncluttered and ensure that there is adequate lighting.
9
Keep children and unauthorised persons away from the work area.
9
WARNING! The warnings, cautions and instructions discussed in this manual cannot cover all possible conditions and situations that may
‰
occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied by the
operator.
2. INTRODUCTION
Double sided rack for safe and tidy workshop storage of most vehicle bumpers. Heavy duty construction ideal for use in body shops. Four pairs
of height adjustable support arms for maximum capacity and flexibility. Fitted with four castors, two with brake, for maximum manoeuvrability
and safe positioning.
3. SPECIFICATION
Model No ....................................................................... RE55
Width ........................................................................ 1170mm
Height ...................................................................... 2180mm
Arm length .................................................................. 520mm
Safe working load......................................................... 160kg
4. ASSEMBLY
4.1. Check quantities of parts.
Item Description
1 Horizontal top bar
2 Vertical support bar
3 Horizontal bottom bar
4 Base bar
5 Bumper support bar
6 Casters
7 Knob
8 Bolt, Washers, Nut
9 Bolt, Washers, Nut
10 Bolt, Washers, Nut
© Jack Sealey Limited
4-LEVEL BUMPER RACK
RE55.V6
MODEL NO:
Qty.
1Pc
2Pcs
1Pc
2Pcs
8Pcs
4Pcs
8Pcs
2Sets
8Sets
16Sets
Original Language Version
RE55.V6 | Issue:2 (3) 04/06/20