Sealey RPS6 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SAFETY
 WARNING! Before use, ensure that there is nothing attached to the front forks, the fairing, or the rear end of the motorcycle, that
will foul the stand.
 Maintain the stand in a good clean condition for the best and safest performance.
 Locate the stand and motorcycle in a suitable area. Keep area clean and tidy and free from unrelated materials and ensure that
there is adequate lighting. Also ensure that the floor/ground is level and strong enough (preferably concrete) to take the weight
of the stand and the motorcycle.
 DO NOT mount the stand on tarmacadam, as the surface may be unstable.
Maintain correct balance and footing whilst positioning the motorcycle on the stand, do not over reach and wear non-slip footwear.

 Ensure that the floor is not slippery.
 Keep children and unauthorised persons away from the work area.
 DO NOT use the stand for a purpose it is not designed to perform.
 DO NOT operate the stand if it is damaged.
 DO NOT use the stand when you are tired or under the influence of alcohol, drugs or intoxicating medication.
 DO NOT allow untrained persons to operate the stand.
DO NOT make any modifications to the stand.

 Before removing a motorcycle from the stand, ensure that there are no obstructions or persons around the motorcycle.
Keep hands and fingers away from moving parts and support pins.

 If using as a front stand, always use in conjunction with a suitable rear stand to ensure full stability.
 DO NOT operate the stand if parts are missing or damaged.
 DO NOT attempt to transport a load on the stand.
 When not in use, store in a safe, dry, childproof location.
2. INTRODUCTION
Lifts and stabilises the front or rear of any dual sided swing armed bike quickly and easily. Supplied with width and angle adjustable rubber
support pads and bobbin supports, front lifting pin type supports and interchangeable handles. All supports mounted on heavy-duty box
section for continuous professional use.
3. SPECIFICATION
Model No: ....................................................................... RPS6
Minimum/Maximum Front Support Width: ............. 170-260mm
Minimum/Maximum Rear Support Width: .............. 130-270mm
4. ASSEMBLY
4.1. The stand is flat packed and requires minimal assembly before first use.
4.1.1. Attach the two side frames to the main handle frame using a nut, bolt and two washers for each side. Normally use the narrow handle
for front fitment and the wide handle for rear fitment. Ensure that the nuts and bolts are fitted correclty, and tighten them so that there
is no movement in the stand. Ensure that the stand sits squarely when placed on the ground.
4.1.2. Fit the required supports - the flat rubber supports (fig.1) or bobbin supports (fig.3), for rear fitment, or the fork supports (fig.2) for front
fitment.
© Jack Sealey Limited
INSTRUCTIONS FOR:
MOTORCYCLE FRONT/REAR COMBINATION
STAND
RPS6
MODEL No:
Minimum/Maximum Bobbin Support Width: . . . . . . . 230-350mm
Maximum Weight:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100kg
fig.1
Original Language Version
fig.2
RPS6 Issue: 2(I) - 10/03/15