Maintenance; ❶ Cleaning Or Replacing The Filter - Canon LV-7370 User Manual

6. Maintenance

This section describes the simple maintenance procedures you should follow to clean the filter and replace the lamp.
❶ Cleaning or Replacing the Filter
The air-filter sponge keeps dust and dirt from getting inside the projector and should be frequently cleaned. If the
filter is dirty or clogged, your projector may overheat.
NOTE: The message for filter cleaning will be displayed for one minute after the projector is turned on or off.
To cancel the message, press any button on the projector cabinet or the remote control.
CAUTION
• Turn off the projector, turn off the main power switch and unplug the projector before replacing the filter.
• Only clean the outside of the filter cover with a vacuum cleaner.
• Do not attempt to operate the projector without the filter cover.
To clean the ar-filter:
Vacuum the filter-through the filter cover.
NOTE: When turning over the projector, slowly place it on a soft cloth so as not to scratch the cabinet.
To replace the filter (sponge):
1. Remove the filter cover (2 locations) by pushing up on the tab of the cover.
2. Replace two filters.
(1) gently peel off the filter (sponge) and clean the filter cover.
(2) attach the new filter to the filter cover.
tab
67