Laser Pointer Function; Pointer Function - Canon LV-5210 Owner's Manual

Laser Pointer Function

This remote control unit emits a laser beam as the Laser pointer function from the laser light window. When the LASER
button is pressed, the laser light goes on. When the LASER button is being pressed for more than 1 minute or the LASER
button is released, light goes off. The signal emission indicator lights red and laser is emitted with red light to indicate laser
beam is being emitted.
The laser emitted is a class II laser; therefore, do not look into the laser light window or shine the laser beam on yourself or
other people. The marks below are caution labels for laser beam.
CAUTION : Use of controls, adjustments or performance of procedures other than those specified herein may result in
hazardous radiation exposure. Do not look into the laser light window while laser is emitting, otherwise eye
damage may result.
Signal Emission Indicator
Laser Light Window

Pointer Function

You can move Spotlight or Pointer of the projector with the remote control unit to emphasize a part of the projected image.
(See "Pointer" on page 40 for changing the patterns and sizes.)
1 While pressing the MENU button, hold down the NO SHOW
button for more than 7 seconds so that the Pointer function
can be available. (The Laser pointer function has switched to
the Pointer function.)
2 Press the LASER button on the remote control unit toward
the projector and see if the LASER button lights green, and
Spotlight or Pointer is displayed on the screen. Then you can
move Spotlight or Pointer with the PRESENTATION
POINTER button. If the LASER button does not light green
and still emits a laser beam, the Laser pointer function has
not switched to the Pointer function yet. Try these steps
until the LASER button lights green.
3 To clear the Spotlight or Pointer displayed on the screen,
press the LASER button toward the projector and see if the
LASER button turns off.
To use the Laser pointer function once again, while pressing
the MENU button, hold down the NO SHOW button for
more than 7 seconds.
Spotlight
NOTE
G
You can choose the size of Spotlight (Large, Middle, and Small) and the
pattern of Pointer (Arrow, Finger, and Dot) in the Setting Menu. See
"Pointer" on page 40.
Pointer
Part Names and Functions
These caution labels are put on the remote control.
PRESENTATION POINTER button
MENU button
NO SHOW button
Hold down the MENU button and the
NO SHOW button at the same time for
more than 7 seconds.
PRESENTATION POINTER button
LASER button
After the Laser pointer function has
switched to the Pointer function, the
LASER button is used as the Pointer
function ON-OFF switch instead of the
Laser pointer function.
Press the LASER button toward the
projector and see if it lights green.
13