Mitsubishi Electric MA-E100R-E Instruction Manual page 16

Cleaning (Cont.)
Approximately Once Every Six Months
Lens of PM2.5 Sensor
1
Remove the cover of the PM2.5
Sensor.
2
Clean the lens with a dry cotton swab.
Do not use water, alcohol, detergent, etc.
This may cause a malfunction.
3
Attach the cover of the PM2.5
Sensor.
16
When There is an Odor Coming Out of the Air Outlet
Activated charcoal filter
1
Remove the inlet panel, pre-filter,
and HEPA filter.
2
Remove the activate charcoal filter.
P.10
3
Soak and wash the activated
charcoal filter.
Soak in cold or
lukewarm water for
approximately one
hour and then wash
in water.
Do not use detergent. Also, do not scrub it.
This may cause the activated charcoal filter to become
damaged.
4
Allow the activated charcoal filter to
dry.
Allow them to dry properly in a well-ventilated place in the
shade for approximately six hours (the drying time differs
depending on the season and climate).
l Do not use them while they are still wet.
Water drops may be blown from the air outlet and an
odor may be created.
l Soaking and washing will not completely restore the
deodorizing performance of the activated charcoal
filter. Replace this filter when the time for replacement
is reached.
5
Attach the activated charcoal filter
to the main unit.
6
Attach the HEPA filter, pre-filter, and
inlet panel to the main unit.
P.10
P.8
P.8