Advertisement
4. OperatiOn
4.1.
ensure all measuring surfaces are clean and then turn on calliper by pressing on/off control. Wait at least one second before use.
4.2.
Loosen locking screw and close the calliper; if read-out does not show zero when in closed position, reset by pressing zero control.
4.3.
select inch or mm units, as required, with the metric/imperial selector. check that display shows the required units.
4.4.
measurements will now be shown directly on the lcd display.
4.5.
A new zero may be obtained, at any open position of the calliper, by pressing the zero control.
4.6.
A second measurement that then also needs to be added to the first one can be obtained by pressing the ABS/0 switch after obtaining
the first measurement (display will show 'INC'), then move the callipers to measure the second one. After noting this, press the ABS/0
switch again and the display will show the total of both measurements.
5. battery fitting
5.1.
A flashing display indicates that the battery is exhausted - replace as follows:
5.2.
Switch off and then remove battery cover (9) by firmly sliding towards the right.
5.3.
Remove exhausted battery and fit replacement with positive side uppermost (fig.1). Refit battery cover.
5.4.
Dispose of old battery in a safe and approved manner. dO nOt burn.
5.5.
If the display fails to alter when the slide is moved, remove the battery - wait at least 30 seconds and then refit the battery.
fig.1
Weee regulatiOnS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
envirOnment prOtectiOn
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
battery remOval
under the Waste Batteries and Accumulators regulations 2009, Jack sealey ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance scheme. Jack
Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705.
note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey group, Kempson Way, Suffolk business park, bury St edmunds, Suffolk. ip32 7ar
01284 757500
© Jack sealey limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
AK9623EV | Issue 2(L) 10/07/17
Advertisement
