Sealey AK9621EV Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions
and maintained properly, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to instruction
manual
1. SAFETY
 WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using tools
and equipment.
 DO NOT use AK9621EV if damaged.
 Maintain AK9621EV in good and clean condition for best performance.
 Keep children and unauthorised persons away from the work area.
 DO NOT use the AK9621EV for any purpose other than for which it is designed.
 DO NOT get AK9621EV wet or use in damp or wet locations, or areas where there is condensation. Keep AK9621EV clean and dry using a
dry cotton cloth only.
 DO NOT expose AK9621EV to bright sunlight or dust.
 DO NOT dismantle AK9621EV.
 DO NOT apply any voltage to the AK9621EV.
 The AK9621EV is a precision instrument, treat with care, avoid using force and do not subject to knocks or shocks.
 Use AK9621EV in reasonably constant temperature conditions of approximately 20
 When not in use, turn off and store gauge in a safe, dry, childproof location.
2. INTRODUCTION
Hardened and tempered stainless steel digital caliper with satin finish. Large LCD display with 11mm high figures for ease of reading. Metric and
Imperial calibration with conversion between the two. Zero setting control allows comparative measurement.
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .AK9621EV
Range: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0-150mm(0-6")
Resolution: . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.01mm(0.0005")
Accuracy <100mm:. . . . . . . . . . . . . . . . . . . . . . ±0.03mm(0.001")
Accuracy >100mm:. . . . . . . . . . . . . . . . . . . . . . ±0.03mm(0.001")
Battery: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 x LR44 (supplied)
fig.1
© Jack Sealey Limited
INSTRUCTIONS FOR:
DIGITAL VERNIER CALIPER 0-150mm/0-6"
STAINLESS STEEL
AK9621EV
MODEL NO:
Original Language Version
C.
O
1 Internal Measure
2 mm\inch Button
3 Locking Screw
4 Fine Adjust Wheel
5 LCD Display
6 External Measure
7 On/Off Button
8 Zero Button
9 Battery Cover
10 Depth Measure
11 Step Measure
AK9621EV Issue: 2 - 07/09/17