Download Print this page
Sealey AK9991 Manual

Sealey AK9991 Manual

Digital inclinometer with laser

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Warning:
instructions
Laser Beam
1.
SAFETY
1.1.
GENERAL SAFETY
Maintain the inclinometer in good condition. Check controls and display functions on a regular basis.
9
Keep the inclinometer and charger cable clean for best and safest performance.
9
Wear approved safety eye protection.
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
9
Keep children and unauthorised persons away from the working area.
9
DO NOT use the inclinometer for a task it is not designed for.
8
DO NOT operate the inclinometer when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT get the inclinometer or charger cable wet or use in damp or wet locations.
8
Keep inclinometer and charger cable in a safe, dry, child proof area where the temperature will not exceed 104°F (40°C).
9
ELECTRICAL SAFETY FOR USE OF USB CABLE
The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualified
electrician, using a Portable Appliance Tester (PAT), at least once a year.
The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance and
the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.
You must ensure that you:
Inspect the charge cable and connector for wear and damage to ensure items are safe before connecting to the power supply. If worn
9
or damaged DO NOT use.
DO NOT use any other type of charger with this product.
8
DO NOT try to take the unit and charge lead apart.
8
DO NOT get the inclinometer wet, or use in wet, damp conditions.
8
WARNING! The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions and
situations that may occur. It must be understood that common sense and caution are factors which must be applied by the operator.
1.2.
BATTERY SAFETY
WARNING! To reduce the risk of burns or fire:
DO NOT attempt to open, dismantle, modify or service the battery.
8
DO NOT crush, puncture, short external contacts or dispose of in fire or water. DO NOT expose to temperatures above 60°C (140°).
8
Recycle or dispose of used equipment as stipulated by local regulation.
9
1.3.
LASER SAFETY
The VS900.V4 utilises a Class II laser that emits low levels of visible radiation (i.e. wavelengths between 400 and 700 nanometres)
which are safe for the skin but not inherently safe for the eyes. The Class II emission limit is set at the maximum level for which eye
protection is normally afforded by natural aversion responses to bright light. Accidental eye exposure is therefore normally safe,
although the natural aversion response can be overridden by deliberately staring into the beam, and can also be influenced by the use
of alcohol or drugs.
WARNING! DO NOT look or stare into the laser beam as permanent eye damage could result.
Be aware that reflections of the laser beam from mirrors or other shiny surfaces can be as hazardous as direct eye exposure.
2.
INTRODUCTION
Digital inclinometer with laser line and four magnetic sides for measuring angles and tilt percentages on metal and other surfaces. Wide
range of uses including setting suspension camber and caster, collision avoidance bumper mounted radar and parking assist systems.
Absolute zero measure on any flat surface with accuracy ±0.2° and measuring range 4x90°. Large backlit LCD display makes it easier
to see in a low-lit environment. Power supply 3.7V lithium battery. USB Type-C (cable included).
3.
SPECIFICATION
Model No:........................................................... AK9991
© Jack Sealey Limited
DIGITAL INCLINOMETER WITH LASER
AK9991
MODEL NO:
Original Language Version
AK9991
Issue 2 (F)
16/10/2023

Advertisement

loading

Summary of Contents for Sealey AK9991

  • Page 1 AK9991 MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2 BATTERY REMOVAL Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.