Advertisement
LUTRON
®
Energi Savr Node
Using a LUT-ELI-3PH unit with an Energi Savr Node unit ensures that the system is compliant with UL924. Follow the
wiring diagram in the LUT-ELI-3PH for mains wiring. Use the diagram below to complete the installation. There can be up
to 32 Energi Savr Node units connected to one LUT-ELI-3PH unit.
Model QSN-4T16-S is shown below.
Check documentation of your particular model for proper terminal connections.
Wiring to Energi Savr Node Unit
Wiring Summary:
• Wire power pack red wire (+24 V) to LUT-ELI-3PH unit terminal 8 (V+).
• Wire power pack black wire (Common) to LUT-ELI-3PH unit terminal 7 (Circuit Common) and to Energi Savr Node
'Com' terminal of Emergency Contact Closure Input.
• Wire Signal wire from LUT-ELI-3PH unit (terminal 1) to Energi Savr Node 'Emerg' terminal of Emergency Contact
Closure Input.
• Removing power from LUT-ELI-3PH unit sends all programmed zones to emergency light levels (Default is typically 100%).
• Reapplying power to LUT-ELI-3PH unit causes all programmed zones to return to previous light levels.
Note:
When normal power fails and the LUT-ELI-3PH unit trips, the signal output changes state and all loads will turn
on to their emergency light level.
Note:
The LUT-ELI-3PH unit includes 2 Fire Alarm Control Panel (FACP) inputs as well. Consult the LUT-ELI-3PH unit
instructions for wiring details.
S P E C I F I C AT I O N S U b M I T TA L
Job Name:
Job Number:
Units
TM
From Normal/
Emergency supply
Model Numbers:
LUT-ELI-3PH
*PP-120H or PP-277H
Hot
Power
pack*
Neutral
Com – Common
Emerg – Emergency
Power Accessories
P/N 369-299B
Rasterized
24 V
Common
100-347 V
Normal
supply
GND
12
12
11
11
10
10
9
9
8
8
CLASS 2 LOW VOLTAGE WIRING
Page
9 11.11.10
7
7
6
6
5
5
4
4
3
3
2
2
1
1
S1
9
Advertisement
Need help?
Do you have a question about the LUT-ELI-3PH and is the answer not in the manual?
Questions and answers