Closed Limit Programming - Pull To Open - Mighty Mule TS571W Installation Manual

Step 1: Enter the primary arm limit programming mode.
With the power on for your control box, press and hold both the  and the
the buzzer sounds, and then release them.
Step 2: Program the primary arm closed limit.
1. Next, press and hold  and you will hear a long beep and the arm will begin to extend, closing the gate. Continue holding the
button down until the gate reaches the desired closed position, and then release.
2. If you overshoot the desired closed position, you can use  to reverse the gate.
3. Adjust as needed until you are totally satisfied with the closed position. Then, press and hold
then release.
NOTE:
If you hear three short beeps in succession, that means that the programming mode has timed out and you will
need to enter the programming mode again. You do not have to start the positioning all over. If the closed position is already
correct but you have timed out, press and hold  and
and hold until the buzzer sounds and then release.
TS571W Installation Instructions

CLOSED LIMIT PROGRAMMING - PULL TO OPEN

Closed Limit Programming
For Pull-to-Open Applications
LED 1
LED 2
LED 3
Button Configuration
● S2 =  (Extend/Close)
● S3 =
● S4 =  (Retract/Open)
S2
S3
S4
buttons at the same time until LED 1 turns on and
until the buzzer sounds, then release. Then, immediately press
36
until the buzzer sounds, and