Table of Contents
Advertisement
Installation
On/Off
Press and hold the
button to turn on the robot. The power
indicator will turn on and the robot will enter Standby mode.
If the robot is in Sleep mode, press and hold the
turn it off and end the current cleanup.
Note:
The robot cannot be turned off when it is charging.
Start cleanup
Press the
button to start cleaning. Once started, the robot
will plan its cleaning route based on its scan of the area. It
cleans along the edges of a zone first and then moves in a
Z-shaped cleaning route to cover the internal area efficiently
and thoroughly.
Zone �: Clean
Zone �: Pending
button to
Zone �: Clean
Zone �: Cleaning
Note:
· Cleaning cannot start if the battery level is too low. Allow the robot to charge
before restarting cleanup.
· Tidy away any cables on the ground (including the power cable of the charging
dock) before cleaning to avoid losing power or damaging either the robot or the
connected device.
· If a cleanup finishes within �� minutes, cleaning repeats by default
· If the battery runs low before cleanup is complete, the robot will carry out a
top-up charge before resuming cleanup from where it left off.
Pause
When the robot is cleaning, press any button to pause it.
Then press the
button to continue cleaning or the
tonto return it to the charging dock and stop the cleaning
cycle.
Note:
Placing a paused robot on the charging dock manually will end the current cleanup.
Sleep
If the robot is paused for over ��-minutes, it will go to sleep,
and its power indicator will flash slowly. Press any button to
wake it back up.
Note:
· The robot will not go to sleep when it is on the charging dock.
· The robot will automatically shut down if left in sleep mode for more than �� hours.
��
but-
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the S5 Max and is the answer not in the manual?
Questions and answers