Fastening The Drive Module By Top To The Cabinet Frame; Fastening The Drive Module To Wall (Wall-Mounted Units Only, Not For Base-Mounted Units); Requirements For Protection; Requirements For The Wall - ABB ACS800 Cabinet Installation And Operating Instruction

Fastening the drive module by top to the cabinet frame

In addition to the base fastening, it is recommended to fasten the module to the
cabinet also from the fastening points at the top. Refer to
the vertical fastening points.
If the module is not fastened from the back top to the cabinet frame, it must be
fastened from the front top fastening points during transportation or in case of
vibration.
Fastening the drive module to wall (wall-mounted units only, not for base-mounted
units)

Requirements for protection

The drive module must be protected against contact, dust and humidity (see chapter
Technical data in ACS800-04/04M/U4 Hardware Manual [64671006 (English)].

Requirements for the wall

The wall must be as close to vertical as possible, of non-flammable material and
strong enough to carry the weight of the unit. Check that there is nothing on the wall
to inhibit the installation.

Floor

The floor/material below the installation must be non-flammable.
Mechanical installation of non-pre-assembled units (ACS800-04M)
Dimensional drawings
81
for