Set Up A Bridge For A Vlan Tag Group [Router Mode] - NETGEAR WiFi 6 AX1800 User Manual

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
If your browser displays a security warning, dismiss the warning. For more information,
see Find the IP address of the AP when you cannot use routerlogin.net on page 32.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > VLAN / Bridge Settings.
The VLAN / Bridge Settings page displays.
5. Select the Enable VLAN / Bridge group check box.
The page expands.
6. Select the By bridge group radio button.
The page adjusts.
7. Select the check box for the LAN port (Port 1, Port 2, Port 3, or Port 4) or WiFi
network (Wireless1, Wireless2, or Wireless2) to which the device that must
circumvent the AP's NAT service is connected.
You must select at least one LAN port or one WiFi network. You can select more
than one LAN port and WiFi network.
8. Click the Apply button.
Your settings are saved. You might need to reconnect to the AP.

Set up a bridge for a VLAN tag group [router mode]

If the AP is in router mode and a device such as an IPTV is connected to a LAN port or
WiFi network, your ISP might require you to set up a bridge for a VLAN tag group for
the AP's Internet (WAN) port.
If you are subscribed to an IPTV service, the ISP might require you to use VLAN tags on
the AP to distinguish between the Internet traffic and the IPTV traffic. A bridge with a
VLAN tag group allows packets that are sent between the IPTV device and the AP Internet
(WAN) port to circumvent the AP's NAT service, which otherwise could drop the packets.
The AP includes a default VLAN tag group with the name Internet, with VLAN ID 10,
and with all LAN ports, WiFi networks, and the WAN port as members. If you enable
the bridge for a VLAN tag group, this default VLAN tag group is also enabled. To allow
one or more devices to send and receive traffic over a separate VLAN, you can add
custom VLAN tag groups, and assign a VLAN ID, priority value, and one or more ports,
wireless network, or both to each VLAN tag group.
Network Settings 127 User Manual