Set Up A Bridge For A Vlan Tag Group [Router Mode] - NETGEAR WAX204 User Manual

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
The VLAN / Bridge Settings page displays.
5. Select the Enable VLAN / Bridge group check box.
The page expands.
6. Select the By bridge group radio button.
The page adjusts.
7. Select the check box for the LAN port (Port 1, Port 2, Port 3, or Port 4) or WiFi
network (Wireless1, Wireless2, or Wireless2) to which the device that must
circumvent the access point's NAT service is connected.
You must select at least one LAN port or one WiFi network. You can select more
than one LAN port and WiFi network.
8. Click the Apply button.
Your settings are saved. You might need to reconnect to the access point.

Set up a bridge for a VLAN tag group [router mode]

If the access point is in router mode and a device such as an IPTV is connected to a LAN
port or WiFi network, your ISP might require you to set up a bridge for a VLAN tag group
for the access point's Internet (WAN) port.
If you are subscribed to an IPTV service, the ISP might require you to use VLAN tags on
the access point to distinguish between the Internet traffic and the IPTV traffic. A bridge
with a VLAN tag group allows packets that are sent between the IPTV device and the
access point Internet (WAN) port to circumvent the access point's NAT service, which
otherwise could drop the packets.
The access point includes a default VLAN tag group with the name Internet, with VLAN
ID 10, and with all LAN ports, WiFi networks, and the WAN port as members. If you
enable the bridge for a VLAN tag group, this default VLAN tag group is also enabled.
To allow one or more devices to send and receive traffic over a separate VLAN, you can
add custom VLAN tag groups, and assign a VLAN ID, priority value, and one or more
ports, wireless network, or both to each VLAN tag group.
CAUTION: Unless you are comfortable with advanced network configurations, be sure
to follow the directions of your ISP. Incorrect configuration might cause the Internet
connection of the access point to go down.
To set up a bridge for a VLAN tag group and enable the new VLAN tag group:
1. Launch a web browser from a computer or mobile device that is connected to the
access point network.
2. Enter http//www.routerlogin.net in the address field.
Network Settings 123 User Manual