Editing Numerical Values - ABB Relion SAM600-IO Operation Manual

Section 5
Using the HMI
5.1.9.1

Editing numerical values

1. Select Main menu /Settings and then a setting.
The last digit of the value is active.
IEC17000244 V1 EN-US
Figure 21:
2.
Press
One press increases or decreases the value by a certain step. For integer values, the change
is 1, 10, 100 or 1000 (...) depending on the active digit. For decimal values, the change can be
fractions 0.1, 0.01, 0.001 (...) depending on the active digit.
3.
Press
4. To select the minimum or maximum value, select the arrow symbol in front of the value.
•
•
If the value is already at either end value (minimum or maximum), it requires two presses to
change it to the opposite end value.
After pressing
Another press of
value is ↕, when the previous value is shown.
32
Last digit is active and it can be increased or decreased
to increase or to decrease the value of an active digit.
For parameters with defined steps, digits smaller than the step value cannot be
edited.
or to move the cursor to another digit.
To set the value to the maximum, press
To set the value to the minimum, press
, the previous value can be restored by pressing
or sets the value to the lower or higher limit. The symbol in front of the
© 2017 - 2021 Hitachi Power Grids. All rights reserved
IEC17000244-1-en.vsd
.
.
Switchgear control unit SAM600-IO
1MRK 500 131-UEN Rev. C
AMU0600415 v14
once, and vice versa.
Operation manual