Installation - NEC SL1000 Getting Started Manual

SL1000 Getting Started Guide

Installation

1. General Precautions
 To avoid shock or damage, do not plug in or turn the system power on before completing the installation
process.
 Avoid working with the KSU during electrical storms.
 Use only commercial AC power to prevent shock or fire.
 Use the power cord supplied for the KSU.
 Do not bundle AC Power cords together, the cords may overheat.
 Make sure the KSU has proper Earth ground connection.
2. Site Requirements
• The system should be wall-mounted only. Ensure that enough space is available to allow the installation
of KSU(s) and/or battery box.
3. Environmental Requirements
Meeting established environmental standards maximizes the life of the system. Make sure that the site
is not:
 In direct sunlight or in hot, cold or humid places.
 In dusty areas or in areas where sulfuric gases are produced.
 In places where shocks or vibrations are frequent or strong.
 In places where water or other fluids comes in contact with the equipment.
 In areas near high-frequency machines or electric welders.
 Near computers, telexes, microwaves, air conditioners, etc.
 Near radio antennas (including shortwave)

If you are installing the expansion KSU ensure there is sufficient wall space and ventilation. Refer to the wall
mounting diagrams below;
Have 300mm on the left
side of the system for AC
power cable.
Have 200mm above the
system for ventilation.
375
Have 200mm below the
system for other cables
connected to the system.
12
Have 300mm on the right
side of the system.