Sealey GSA53 Instructions

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH
IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE
THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
WARNING! Ensure Health & Safety, local authority and general workshop practice regulations

are adhered to when using this equipment.
 WARNING! Disconnect from air supply before changing accessories or servicing.
 Maintain the tool in good condition and replace any damaged or worn parts. Use
genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
 WARNING! Check correct air pressure is maintained and not exceeded. We recommend 90psi.
 Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each
use and ensure that all connections are secure.
 Wear approved safety eye/face shield, ear defenders and hand protection.
 Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
 Keep children and non essential persons away from the working area.
 DO NOT use the tool for a task it is not designed to perform.
 WARNING! DO NOT use tool if damaged or thought to be faulty. Contact Sealey service
agent.
 DO NOT use tool unless you have been instructed in its use by a qualified person.
 DO NOT carry the tool by the air hose, or yank the hose from the air supply.
 DO NOT operate tool if you are tired or under the influence of alcohol, drugs or intoxicating
medication.
 DO NOT carry tool with your hand on the power trigger in order to avoid unintentional starting.
 DO NOT direct air from the air hose at yourself or others.
 When not in use disconnect from air supply and store in a safe, dry, childproof location.
2. INTRODUCTION & SPECIFICATION
Suitable for cutting straight lines in metal sheet. Fingertip throttle control with alloy head and
housing. Blades are consumable items and are not covered by warranty.
Maximum cutting capacity . . . . . 1.2mm(Steel)
Air consumption . . . . . . . . . . . . . . . . . . . . 4cfm
Operating pressure. . . . . . . . . . . . . . . . . . 90psi
Air inlet size . . . . . . . . . . . . . . . 1/4"BSP
Weight . . . . . . . . . . . . . . . . . . . . . 1.1kg
Original Language Version
INSTRUCTIONS FOR
AIR SHEARS
GSA53
MODEL No:
GSA53 Issue: 2 - 30/10/09