Sealey TC904 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instruction protection
manual
1. SAFETY
Ensure the bead seating tool is in good condition before use.

Before carrying out maintenance on the unit ensure that the pressure has been vented.

Use only authorised attachments and parts. Unauthorised items may be dangerous and will invalidate your warranty.

Keep the work area clean and tidy.

Ensure the working area is well lit.

Always wear safety glasses and ear defenders when using the bead seater.

Keep children and unauthorised persons away from the working area.

WARNING: DO NOT discharge unless the nozzle is positioned on the wheel rim.

DO NOT use the bead seater to perform a task for which it is not designed.

DO NOT deface, or remove, the certification plate attached to the bead seater.

DANGER! DO NOT direct compressed air towards people or animals.

WARNING! The bead seater is a pressure vessel and the following safety measures apply:

DO NOT use the bead seater without the safety valve fitted.

DO NOT tamper with the safety valve, DO NOT modify or alter the bead seater in any way and DO NOT strap anything to it.

DO NOT subject the bead seater to impact, vibration or heat and DO NOT allow contact with abrasives or corrosives.

Drain condensation from bead seater daily, inspect inside walls for corrosion every three months and have a detailed inspection carried

out annually. The bead seater shell must not fall below the certified thickness at any point.
WARNING! The warnings, cautions and instructions discussed in this manual cannot cover all possible conditions and situations
that may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator.
2. INTRODUCTION
The easy and instant way to seat tubeless tyre beads. Dumps air into tyre void forcing bead to seat against rim for inflation. Air release is
controlled by a diaphragm valve and push-button trigger. Features slotted key to prevent accidental operation of the trigger. Fully certified tank
with gauge and safety valve prevents over pressurising. Suitable for use on cars, commercials, agricultural and ATV tyres.
3. SPECIFICATION
Model No: ................................................................... TC904
Maximum Pressure: ...................................... 150psi(10.4bar)
Tank Capacity: ................................................................ 19ltr
Weight: ........................................................................ 13.2kg
© Jack Sealey Limited
INSTRUCTIONS FOR:
BEAD SEATING TOOL 19ltr - PUSH BUTTON
TRIGGER
TC904
MODEL NO:
Wear protective
Wear ear
gloves
protection
fig.1
Original Language Version
fig.2
TC904 Issue:1 - 16/01/18