Sealey TSTVRK Instructions

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained,
give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS
AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO
DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS
SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
 WARNING! Ensure Health and Safety, local authority and
general workshop practice regulations are adhered to
when using tools.
 WARNING! DO NOT use this tool on an inflated tyre,
ensure that all air pressure has been expelled before
attempting to replace the tyre valve.
 Ensure that a vehicle which has been jacked up is
adequately supported with axle stands.
 DO NOT use tools if damaged.
 Maintain tools in good and clean condition for best and
safest performance.
 Wear approved eye protection. A full range of personal
safety equipment is available from your Sealey dealer.
 Wear suitable clothing to avoid snagging. DO NOT wear
jewellery and tie back long hair.
 DO NOT use on wheels with inner tubes.
 DO NOT use on alloy wheels.
 DO NOT use this tool when you are tired, under the
influence of alcohol, drugs or intoxicating medication.
 DO NOT use this tool for any purpose other than that for
which it is designed.
 DO NOT use this tool if any part of it is damaged.
 DO NOT allow untrained persons to use this tool.
 When not in use, clean and store in a safe, dry, childproof
area.
 WARNING! The warnings, cautions and instructions in
this manual cannot cover all possible conditions and
situations that may occur. It must be understood that
common sense and caution are factors which cannot
be built into this product, but must be applied by the
operator.
2. INTRODUCTION & CONTENTS
2.1 Introduction
Remove and install leaking tyre valves without having to
remove the tyre. Works on steel wheels and especially good
for valves on motorcycles or agricultural wheels. Time saving
tool. Not suitable for high pressure valves.
2.2 Contents (fig.1)
fig.1
© Jack Sealey Limited 2012
Instructions for:
Tyre Valve Removal/Installation Tool
TSTVRK
Model No:
3. OPERATION
WARNING! Ensure that you read, understand and

apply Section 1 safety instructions.
3.1 Removing Tyre Valve from Wheel
3.1.1 Using a suitable lubricant, lubricate the valve hook tool
and the area around the tyre valve.
3.1.2 Push the tyre valve body to one side and insert the
valve hook tool between the tyre valve and the valve
hole in the wheel rim (fig.2).
3.1.3 Turn the valve hook tool 90° clockwise so that the hook
is under the tyre valve.
3.1.4 Lift the valve hook tool and pull the tyre valve from the
wheel rim (fig.3).
Original Language Version
fig.2
fig.3
TSTVRK Issue: 1 - 23/07/12