Table of Contents
Advertisement
Available languages
Available languages
EN
Problem
Machine does not turn on.
On/Stand-by warning lamp OFF.
The machine will not switch on
after the "On/Stand-by" button
is pressed.
Excessive heating time
(i.e. more than 40 seconds).
20
TROUBLESHOOTING
Possible causes
» The machine is not connected
to the power source.
» The machine is connected to a
faulty power cord.
» Power supply not available in
the household mains.
» The touch interface fails to
respond.
» Wrong simultaneous press of
two buttons.
» The machine is stored at low
temperatures
(e.g. in a cellar or garage).
Solution
» Connected the machine to the
power source.
» Connected the machine directly
to the power source.
» Connect another device to
check the availability of the
power supply.
IF THE PROBLEM CANNOT
BE SOLVED, CONTACT
THE LAVAZZA CUSTOMER
SERVICE.
» Verify that the interface surface
and the user's hands are clean
and dry.
» Wait a few seconds, then press
the "On / Stand-by"
only.
IF THE PROBLEM CANNOT
BE SOLVED, CONTACT
THE LAVAZZA CUSTOMER
SERVICE
» Keep the machine in a suitable
place over at least 1 hour.
Then, plug the machine into the
mains socket and try to switch
it on.
IF THE PROBLEM CANNOT
BE SOLVED, CONTACT
THE LAVAZZA CUSTOMER
SERVICE
button
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the CLASSY PLUS and is the answer not in the manual?
Questions and answers
The orange light for water tank removed is on but the water tank is in place. When I turn on and off it is not on but when I try and brew the light comes back on and will not brew.
The orange light for the water tank on the LAVAZZA CLASSY PLUS may be on even when the water tank is in place due to the following reasons:
1. No water in the tank – Ensure the tank is filled with fresh drinking water.
2. Tank not inserted correctly – Remove and correctly reinsert the water tank.
3. No water flow in the hydraulic circuit – Disconnect the power cord, wait 10 seconds, reconnect it, and turn the machine on. Wait for the heating cycle to complete, as the machine will automatically attempt to fill the hydraulic circuit.
If the issue persists, contact Lavazza Customer Service.
This answer is automatically generated