Sealey SDL11 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Wear eye
Refer to
instructions protection
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
‰
equipment, make sure you know where the nearest fire extinguisher is.
WARNING! Always wear approved eye / face protection when operating the soldering iron.
‰
WARNING! Do not use the soldering iron if you notice damage to the workpiece.
‰
WARNING! Always point the soldering iron away from the eyes and body when during operation.
‰
WARNING! Do not put the soldering iron down, put it back in its holder.
‰
WARNING! Only use in a well ventilated area.
‰
Keep flammable material away from the torch when operating.
9
DO NOT operate the soldering iron when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT use the soldering iron in an area where paint fumes, solvents or other flammable solids, liquids or gases pose a potential
8
hazard.
DO NOT hold any workpiece by hand.
8
DO NOT touch the workpiece close to the heated area as it will be very hot. Allow to cool.
8
DO NOT operate the soldering iron if it is damaged as this may cause failure and/or possible personal injury.
8
DO NOT touch the top of the soldering iron during or immediately after use, as it will be very hot. Allow to cool.
8
DO NOT allow children to operate the soldering iron.
8
When not in use, store away from direct sunlight in a safe, dry, childproof location.
9
DO NOT store at over 40°C, such as in a car in hot weather.
8
2. INTRODUCTION
Cordless and lightweight soldering iron. Inbuilt LED to illuminate soldering area in low light areas such as engine bays. Kit includes
standard, chisel and heat shrink tips as well as cleaning sponge, solder, stand and USB charging lead. Heats up to a maximum
temperature of 600°C and has a 40 minute working time.
3. SPECIFICATION
Model No.:.................................................................. SDL11
Battery: ...................................................... 2.5Ah Lithium-ion
Charging time:................................................................3.5hr
Maximum Temperature: ............................................... 600
Operating Time: ........................................................... 40min
Power Rating: .................................................................30W
Consumables: See fig.1 and table below.
Item
1 Soldering wire for SDL11
2 Charging cord for SDL11
3 Soldering stand for SDL11
4 30W Chisel tip
5 Cleaning sponge
6 30W Cone tip
7 30W Lighter and heat shrink tip
8 Interchangeable tips (set of 3) NOT SHOWN
9 Transparent cap for SDL11 NOT SHOWN
© Jack Sealey Limited
30W LITHIUM-ION RECHARGEABLE
SOLDERING IRON KIT
MODEL NO:
Do not cover
Warning:
Hot surfaces
Description
Original Language Version
SDL11
Indoor use
only
C
0
Part number
SDL11.SW
SDL11.CC
SDL11.S
SDL11.CHT
SDL11.CS
SDL11.CT
SDL11.LHT
SDL11.T
fig.1
SDL11TC
SDL11 Issue 1 11/06/20