Sealey SDL10 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
‰
equipment, make sure you know where the nearest fire extinguisher is.
WARNING! Always wear approved eye / face protection when operating the soldering iron.
‰
WARNING! Do not use the soldering iron if you notice damage to the workpiece.
‰
WARNING! Always point the soldering iron away from the eyes and body when during operation.
‰
WARNING! Do not put the soldering iron down, put it back in its holder.
‰
WARNING! Only use in a well ventilated area.
‰
Keep flammable material away from the torch when operating.
9
DO NOT operate the soldering iron when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT use the soldering iron in an area where paint fumes, solvents or other flammable solids, liquids or gases pose a potential
8
hazard.
DO NOT hold any workpiece by hand.
8
DO NOT touch the workpiece close to the heated area as it will be very hot. Allow to cool.
8
DO NOT operate the soldering iron if it is damaged as this may cause failure and/or possible personal injury.
8
DO NOT touch the top of the soldering iron during or immediately after use, as it will be very hot. Allow to cool.
8
DO NOT allow children to operate the soldering iron.
8
When not in use, store away from direct sunlight in a safe, dry, childproof location.
9
DO NOT store at over 40°C, such as in a car in hot weather.
8
2. INTRODUCTION
Cordless and lightweight soldering iron. Inbuilt LED to illuminate soldering area in low light areas such as engine bays. Heats up to a
maximum temperature of 600°C and has a 40 minute working time.
3. SPECIFICATION
Model No.:.................................................................. SDL10
Battery: ...................................................... 2.5Ah Lithium-ion
Charging time:................................................................3.5hr
Maximum Temperature: ............................................... 600
Operating Time: ........................................................... 40min
Power Rating: .................................................................12W
4. CONTENTS
Item
1 Charging cord for SDL10
2 Soldering stand for SDL10
3 12W Cone tip
4 Transparent cap for SDL10 NOT SHOWN
© Jack Sealey Limited
12W LITHIUM-ION RECHARGEABLE
SOLDERING IRON
MODEL NO:
Do not cover
Warning:
Hot surfaces
Description
Original Language Version
SDL10
Indoor use
only
C
0
Part number
SDL10.CC
SDL10.S
SDL11.CT
SDL10TC
fig.1
SDL10 Issue 1 11/06/20