Table of Contents
Advertisement
V/I Input Point 1 Rate
Program Torque Setpoints
This parameter is used to set the gain and bias of the isolated V/I
input terminal when the V/I terminal is used as the control input
while operating in the Torque Control mode.
V/I Input Torque Control Setup
Perform the following setup to allow the system to receive Torque
Control input at the V/I input terminal:
• Set
SW301
of the Terminal Board to Voltage or Current (see
Figure 9. on pg.
17).
• Program Fundamental Standard Mode Selection
Frequency Mode 1 V/I.
• Program Fundamental Standard Mode Selection
Command Mode Selection Terminal Board.
Torque Control
Perform the following setup to allow the system to perform Torque
Control from the V/I input terminal:
• Set V/I Input Point 1 Rate (F205).
• Set V/I Input Point 1 Setting (F201) — the input analog signal
level that corresponds to the torque setting at V/I Input Point 1
Rate.
• Set V/I Input Point 2 Rate (F206).
• Set V/I Input Point 2 Setting (F203) — the input analog signal
level that corresponds to the torque setting at V/I Input Point 2
Rate.
• Provide a Run command (F and/or R).
Torque Control is accomplished by establishing an associated V/f
output pattern for a given V/I input level.
Once set, as the V/I input voltage changes or the V/I current
changes, the output torque of the ASD will vary in accordance
with the above settings.
This parameter sets V/I Input Point 1 Rate and is the output
torque value that is associated with the setting of V/I Input Point 1
Setting when operating in the Torque Control mode.
This value is entered as 0% to 250% of the rated torque.
Note: When using the isolated V/I input terminal, the IICC
terminal must be used as the return (negative) connection.
106
–
F205
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
F206
Direct Access Number —
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 250.00
Units — %
Torque Settings
https://www.toshiba.com/tic/
F205
Advertisement
Table of Contents
