Troubleshooting - Assa Abloy Besam SL500 User Manual

Troubleshooting

What´s wrong?
The door does not open
The motor does not start
The motor starts but stops during
opening
The door does not close
The motor does not start
The motor starts but stops during
opening
The door moves slowly
If the problem continues, please contact your ASSA ABLOY Entrance Systems representative.
22
Change the setting of the program selector.
If break-out unit PSB is installed, check that the door leaves and side screens
are completely closed.
Check the mains switch and fuse in the building.
Unlock the mechanical locks.
Clean the floor guide.
Check for objects jammed under the door.
Change the setting of the program selector.
If a presence sensor is installed, check for and remove objects placed in the
presence zone.
Clean the floor guide.
Check for objects jammed under the door.
Prevent traffic using the door and allow it to do a complete opening and
closing cycle with low speed.
Reset the operator by pushing the AUTO-symbol on the mode selector and
then push a narrow object on the globe of the logotype on the operator
mode selector.
Allow the operator to control the closed position without interruption.
Issue 2015-10-23
Remedies
1009216-EI-4.0