Advertisement
Available languages
Available languages
Quick Links
Left- and Right-Hand Gearcase Assemblies
For Power Max®, Power Shift® and 824XL Power Throw
Snowthrowers
Model No. 108-7325
Model No. 108-7327
1. Auger shaft
2. Right-hand gearcase
assembly
3. Gasket
4. Thrust washer
Disassembling the Gearcase
1. Remove the gearcase assembly from the
snowthrower.
Note: Refer to service manual 492-9138 or
492-0354.
2. Disassemble the gearcase assembly.
3. Remove and discard the old gasket (if
applicable).
© 2005—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Figure 1
5. Helical gear
6. Pipe plug
7. Left-hand gearcase assembly11. Impeller shaft
8. Woodruff key
Register at www.Toro.com.
Form No. 3353-635 Rev A
Installation Instructions
9. Screw
10. Worm bushing
12. Retaining ring
13. Thrust bearing (0.078 inch
thick)
14. Thrust bearing (0.125 inch
thick)
15. Input bushing
16. Oil seal
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
Advertisement
Related Manuals for Toro 108-7325
Summary of Contents for Toro 108-7325
- Page 1 Form No. 3353-635 Rev A Left- and Right-Hand Gearcase Assemblies For Power Max®, Power Shift® and 824XL Power Throw Snowthrowers Model No. 108-7325 Model No. 108-7327 Installation Instructions Figure 1 9. Screw 1. Auger shaft 5. Helical gear 13. Thrust bearing (0.078 inch thick) 2.
- Page 2 Inspecting the Gearcase 6. Start the 9 screws by hand to avoid cross threading, and torque them in sequence to 135 1. Inspect the gearcase castings for flaws or to 165 in-lb (17.0 N·m). scratches in the gasket surface area, and replace the castings if necessary.
- Page 3 Form No. 3353-582 Rev A Demi-boîtiers d'engrenages gauche et droit Déneigeuses Power Max®, Power Shift® et 824XL Power Throw N° de modèle 108-7325 N° de modèle 108-7327 Installation Instructions Figure 1 1. Arbre de fraise à neige 5. Roue à denture hélicoïdale 9.
- Page 4 Contrôle du boîtier Note: Vous pouvez omettre cette étape si d'engrenages vous montez un demi-boîtier gauche neuf. 6. Commencez à serrer les 9 vis à la main en 1. Examinez les deux moitiés du boîtier et prenant soin de ne pas fausser le filetage, puis remplacez-les si la surface du joint est serrez-les l'une après l'autre à...