Blomberg DWT37300 Installation Manual page 19

Install a strain relief (not supplied) into the
opening on the kick plate. (Figure A)
Pass the electrical supply cable through the
strain relief; make sure the strain relief clamps
the insulated outer casing of your electrical
supply cord and not the wires themselves.
15 / 15 /
Leave 2 " " to 3 " " (75mm / 100mm)
16 16
of insulated wire extending through the strain
relief (Figure B). Tighten the strain relief
screws. (Make sure you can not pull the
electrical cord out) of the strain relief.
Do not pre-twist the wires before connecting
them with wire nuts.
Using the supplied wire nuts, connect the
electrical supply wires to the dishwasher's
wires, black to black, white to white, and green
or bare to green or bare. Make certain that the
insulated wires show no bare wire from the
bottoms of the wire nuts. Gently tug the wires
to make certain they are securely connected
(Figure C).
7.1.6 FASTEN JUNCTION BOX
1. Pull the wires into the junction box. Be sure
that the wire nuts do not loosen.
2. Replace the cover on the junction box.
3. Secure the cover with the screws (Figure D).
16
USA