Blomberg DWT37300 Installation Manual page 18

 Temperatures required for soldering and sweating will damage the dishwasher's water
inlet valve so if any such operation is needed, keep the heat source min. 7
away from the dishwasher's water inlet valve.
 There should not be any sharp bends in the water line that may restrict the water flow.
 Teflon tape or pipe tread compound must be used for sealing the connection. Before
connecting the copper water supply line to the dishwasher, flush it with hot water to clear
any foreign material.
Notice :
After connections are made turn on the water supply to check for leaks.
7.1.4 ELECTRICAL CONNECTION
WARNING
• Make sure the voltage and frequency listed on the data plate correspond with
the household electrical supply. This data must correspond to prevent injury and
machine damage. Consult a qualified electrician if in doubt.
• Only connect the dishwasher to the mains when all installation and plumbing work
is complete.
• Do not use any extension cord or portable outlet device to connect the dishwasher
to a power supply.
7.1.5 GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of a malfunction or breakdown, grounding
will reduce the risk of electric shock by providing a path of least resistance for electric
current. This appliance must be installed and grounded in accordance with all local codes
and ordinances.
WARNING
• Improper connection of the equipment-grounding conductor can result in a risk of
electric shock. Check with a qualified electrician or service representative if you
are in doubt whether the appliance is properly grounded.
7.1.3 WATER SUPPLY CONNECTION
Water supply may be connected to the
dishwasher in one of two ways:
With metal braided hose.
With copper tubing.
CAUTION
Hot water supply line: Use minimum 3/8" O.D.
copper tubing or metal braided dishwasher
supply line.
15
USA
7 /
" (200mm)
8