Download Print this page

VERITAS Tail Vise Quick Release

Download this manual

Quick-Release

Tail Vise

05G30.01

U.S. Des. Pat. No. D671,812

Need help?

Do you have a question about the Tail Vise and is the answer not in the manual?

Page 1 Quick-Release Tail Vise 05G30.01 U.S. Des. Pat. No. D671,812...
Page 2 Generally, retroﬁ tting a tail vise onto an existing workbench requires extreme modiﬁ cations As delivered, the vise is conﬁ gured for mounting on to the workbench, and a new workbench that is to the right end of a workbench;...
Page 3 Use a bit of masking tape The quick-release tail vise should be mounted onto a across the half nut cam and half nut to maintain their workbench with a front apron.
Page 4 ® Veritas Quick-Release Tail Vise 17" × 6 " Tip: Leave a bit of material on the top and front Apron Clear Area of the jaw, then plane it ﬂ ush with the apron and workbench top after ﬁ nal assembly.
Page 5: Installing The Handle
® Veritas Quick-Release Tail Vise " counterbore using Drive the bushings through the base casting and mounting mounting plate holes plate. This ﬁ t is extremely tight. If you need to use a as drill bushing. hammer to drive the bushings into place, position a short length of wood between the bushing and the hammer to avoid damaging the rest of the mechanism.
Page 6: Finishing Touches
Quick-Release Tail Vise Testing the Installation and Installing the Apron This quick-release tail vise is a fairly simple device. Workpieces can be clamped between the jaw and the Release the jaw and test the mechanism to ensure the apron; however, it is more common to clamp workpieces vise can travel fully without excessive binding.

Sliding tail vise