(8) Removing and Replacing the Fan and Blower Motor
1 Remove the power supply control
circuit board.
→ (See "(4) Removing and Replacing
the Power Supply Circuit Board".)
2 Remove the nut, washer B, and fan
spacer, and then remove the fan and
washer A.
→ (Removing and Replacing the Fan)
3 Remove the four motor holder
mounting screws, and then remove the
motor holder.
4 Remove the blower motor while paying
attention to the lead wires.
→ (Removing and Replacing the
Blower Motor)
2
2
Nut
Washer B
3
Motor holder
mounting screw
4
* Take care that the blower motor is not tilted at the
time of reassembly. (The fan and case may come
into contact with each other.)
34
Nut tightening torque:
At least 2.94 N
(30 kgf
cm)
•
Fan spacer
(donut-shaped)
Fan
Washer A
Motor holder
Motor holder
mounting screw
Blower motor
m
•