Aappendix - Mitsubishi Electric 700 Series Installation Manualline

A APPENDIX
A.1 Instructions for Compliance with the European Directives
The EU Directives are issued to standardize different national regulations of the EU Member States and to facilitate free
movement of the equipment, whose safety is ensured, in the EU territory.
Since 1996, compliance with the EMC Directive that is one of the EU Directives has been legally required. Since 1997,
compliance with the Low Voltage Directive, another EU Directive, has been also legally required. When a manufacturer
confirms its equipment to be compliant with the EMC Directive and the Low Voltage Directive, the manufacturer must
declare the conformity and affix the CE marking.
The authorized representative in the EU
The authorized representative in the EU is shown below.
Name: Mitsubishi Electric Europe B.V.
Address: Gothaer Strasse 8, 40880 Ratingen, Germany
Note
We declare that this inverter conforms with the EMC Directive in industrial environments and affix the CE marking on
the inverter. When using the inverter in a residential area, take appropriate measures and ensure the conformity of the
inverter used in the residential area.
A.1.1 EMC Directive
We declare that this inverter conforms with the EMC Directive and affix the CE marking on the inverter.
EMC Directive: 2004/108/EC
Standard(s): EN61800-3:2004 (Second environment / PDS Category "C3")
Notes
First environment
Environment including residential buildings. Includes buildings directly connected without a transformer to the low
voltage power supply network which supplies power to residential buildings.
Second environment
Environment including all buildings except buildings directly connected without a transformer to the low voltage
power supply network which supplies power to residential buildings.
Notes
Install the inverter and perform wiring according to the following instructions.
The inverter is equipped with a built-in EMC filter. Set the EMC filter valid (initial setting).
Connect the inverter to an earthed power supply.
Install a motor and a control cable written in the EMC Installation Manual (BCN-A21041-204) according to the
instruction.
The cable length between the inverter and the motor is 5 m maximum.
Confirm that the inverter conforms with the EMC Directive as the industrial drives application for final installation.
36