Connecting The Water Supply; Connecting The High Pressure Hose - Sealey PC1950 Instructions Manual

1450psi

SET-UP

4.1

CONNECTING THE WATER SUPPLY

Use a reinforced hose pipe with an internal diameter of 1/2” and screw a push fit hose connector to the water inlet on the machine

(fig 1). Connect hose to the mains water supply as indicated in (fig 2).

4.2

Remove and discard the transit plug from the water ‘out’ connector on the lower front of the machine (fig 3). Attach the high pressure

hose to the pressure washer (fig 4) ensuring that the connector is tight. Turn on the water supply.

4.3

ASSEMBLING THE LANCE OR DETERGENT DISPENSER

Push the lance/dispenser onto the gun (fig 5) and turn through 90

until it clicks into place.

PC1950 - 1 - 190105

Table of Contents