ABB Ability Smart Sensor Installation Manual

—
I N S TA L L AT I O N G U I D E
ABB Ability
TM
Installation with aluminum clamping bracket
ATTENTION
Install as per industry codes and regulations
The Smart Sensor should be installed by technically
qualified personnel. Failure to install the sensor in
compliance with applicable codes and regulations and
according to the manufacturer's recommendations
may result in electrical shock, fire hazard,
unsatisfactory performance or equipment failure, and
may void the sensor warranty.
WARNING
Only qualified individuals who are familiar with appro-
priate national codes, local codes and sound practices
should install, repair or modify electric motor and/
or related accessories. Installation should conform to
appropriate codes and practices. Failure to follow these
instructions could result in serious personal injury, death
and/or property damage.
Electrical live circuit hazard. Do not touch electrically
live parts or equipment. For a safe installation,
disconnect, lockout and tagout the asset's power
supply before installing or servicing the sensor.
Smart Sensor for motors
IMPORTANT! Read these
instructions in their entirety before
installing the ABB Ability™ Smart
Sensor for hazardous areas with
aluminum clamping bracket.
CAUTION
Asset surface temperature hazard. The external
surface of an electric motor may reach temperatures
which can cause discomfort, burns or injury to indi-
viduals who come into contact with the hot surface.
For safety reasons the asset should be switched off
and allowed to cool before attempting to install the
sensor. Asset surface temperatures should only be
measured with suitable instruments and not estima-
ted by hand touch or direct skin contact. Failure to
observe this precaution could result in bodily injury.
Do not replace batteries! Incorrect use of batteries
voids the certifications of the Smart Sensor, such as
hazardous area certifications, safety certifications,
and IP rating. Dispose of used sensors according to
instructions.