Behringer EUROPOWER PMP2000 User Manual
10-channel power mixer
Hide thumbs
Also See for EUROPOWER PMP2000:
- User manual (32 pages) ,
- Quick start manual (18 pages) ,
- User manual (19 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Behringer EUROPOWER PMP2000
Summary of Contents for Behringer EUROPOWER PMP2000
- Page 1 User Manual Version 1.2 May 2007...
-
Page 2: Important Safety Instructions
EUROPOWER PMP2000 IMPORTANT SAFETY INSTRUCTIONS CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain and moisture. -
Page 3: Table Of Contents
Because we know that your success is our success, too! I would like to thank all people whose help on “Project PMP2000” has made it all possible. Everybody has made very personal contributions, starting from the designers of the unit to the many staff members in our company and finally to you, the user of BEHRINGER products. -
Page 4: Before Get Started
1.1.2 Initial operation Be sure that there is enough space around the unit for cooling and, to avoid overheating, please do not place the PMP2000 near radiators etc. Before you connect the PMP2000 to the mains, please... -
Page 5: Control Elements
CD player or tape deck, for example. The CD/TAPE/LINE OUT RCA output provides the stereo main mix signal of your PMP2000 and can be routed to, say, a recording machine. When the CD/TAPE OUT signal is connected to a tape... -
Page 6: Rear Panel
Blown fuses should only be replaced by fuses of the same type and rating. Use the POWER switch to put your PMP2000 into operation. The POWER switch should always be in the “Off” position when you are about to connect your unit to the mains. -
Page 7: Loudspeaker Connections
Fig. 4.5: Loudspeaker connector Please be sure to only use commercial Speakon cables (type NL4FC) for connecting your loudspeakers to the PMP2000. Please check the pin assignment of your loudspeakers and cables dependent on the PMP2000 speaker output you choose. -
Page 8: Wiring Examples
5. WIRING EXAMPLES Fig. 5.1: PMP2000 as stereo amplifier (example) Please set the MODE switch for this application! Fig. 5.2: PMP2000 as double mono amplifier (example) For this application, however, please set the MODE switch to “MON/MAIN”! Fig. 5.3: Standard setup (example) to “LEFT/RIGHT”... -
Page 9: Specifications
20 Hz - 20kHz; measured at preamp output. All channels: level controls in center position; EQ flat. Reference = 0 dBu. BEHRINGER is constantly striving to manintain the highest professional standards. As a result of these efforts, modifications may be made from time to time to existing products without prior notice. -
Page 10: Warranty
All trademarks (except BEHRINGER, the BEHRINGER logo, JUST LISTEN and EUROPOWER) mentioned belong to their respective owners and are not affiliated with BEHRINGER.BEHRINGER accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph or statement contained herein. Colors and specifications may vary slightly from product. -
Page 11: Federal Communications Commission Compliance Information
(2) this device must accept any interference received, including interference that may cause undesired operation. Important information: Changes or modifications to the equipment not expressly approved by BEHRINGER USA can void the user’s authority to use the equipment. EUROPOWER PMP2000...
Need help?
Do you have a question about the EUROPOWER PMP2000 and is the answer not in the manual?
Questions and answers