Panasonic AU-EVA1 Manual page 17

Zoom + Focus
The Zoom + Focus control have been implemented on the base of a CANON CN-E 18-80MM T4.4LIS KAS
S
Please notice if a Zoom in/out adjustment have been initiated on a SKAARHOJ controller and one try to
zoom directly on the lens when this is in "servo AUTO mode" the SKAARHOJ controller will overrule
adjustments being done on the lens directly.
Focus must be set to "AF" on the lens itself if focus adjustments should be done from the SKAARHOJ
panel.
If a Focus near/far adjustments have been initiated on a SKAARHOJ controller (while AF is set) the
SKAARHOJ controller will overrule adjustments being done on the lens directly.
Iris
Iris must be set to "A" mode on the lens itself if iris adjustments should be done from the SKAARHOJ
panel.
This is a table of actions for some of the actions in the Panasonic EVA1 Device Core.
Zoom (Creep)
Zoom (Step)
Zoom (Fine)
Zoom (Binary)
SKAARHOJ DEVICE CORES
Initiates a Creep Zoom in/out with speeds between -8 to +8
Binary triggers: Will only reflect the speed of the Creep Zoom value (-8
to +8)
Pulse inputs: Will cycle between -8 to +8. When -8 Creep Zoom out is at
the highest speed. When +8 Creep Zoom in is at the highest speed.
When 0 no zoom is initiated.
Displays: "Creep Zm/Speed of zoom"
Zoom in/out with steps defined to a specific value. Used to quickly zoom
to a desired range
Binary triggers: Will only reflect the current zoom value in mm
Pulse inputs: Will zoom in/out with the given speed value
Speed Limit 1: Small steps
Speed Limit 8: Large steps
Displays: "Step Zm/Zoom range in mm"
Zoom in/out with small steps to a specific value zoom range
Binary triggers: Will only reflect the current zoom value in mm
Pulse inputs: Will zoom in/out in small steps to set a specific zoom
range. Only recommended to use for very small adjustments. Reacts
slow if turned multiple times
Displays: "Fine Zm/Zoom range in mm"
Used to zoom in/out via buttons instead of a encoder
Binary triggers: Zoom in/out as long as a button is pressed and held
down. Speed of the zoom is determined with the speed limiter.
Pulse inputs: Not implemented
Displays: "Zoom/[Out,In]"
17