Sealey VSE5587 Quick Start Manual

Thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. saFeTy
WaRning! ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using tools.
‰
do noT use tools if damaged.
8
ensure that a vehicle which has been jacked up is adequately supported with axle stands and that the wheels are chocked, refer to
9
the vehicle manufacturer's service instructions, or a proprietary manual.
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey stockist.
9
Wear suitable clothing to avoid snagging. do noT wear jewellery and tie back long hair.
9
do noT use air tools to operate the force screw.
8
Maintain tools in good and clean condition for best and safest performance.
9
When not in use, clean and lubricate tool, and store in its storage case in a safe, dry, childproof location.
9
imPoRTanT: The force screw must be kept well lubricated.
imPoRTanT: This manual is provided as a guide only, refer to the vehicle manufacturer's service instructions, or a proprietary
manual, to establish the current procedure and data.
WaRning! Failure to heed safety and warning instructions may result in damage and/or personal injury and will invalidate the
‰
warranty.
WaRning! The warnings, cautions and instructions referred to in this manual cannot cover all possible conditions and situations
‰
that may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but
must be applied by the operator.
2. inTRoducTion
Suitable for removal/installation of rear trailing arm bushes on a Fiat Panda (03-12). Tool will allow changing the bushes in situ, saving time
and money.
3. conTenTs
© Jack Sealey limited
ReaR TRailing aRm Bush Tool - FiaT
Panda
Model no:
Wear protective
clothing
Original Language Version
Vse5587
Part no. description
VSe5587.01 Cup Ø50*10T
VSe5587.02 Cup Ø50*17T
VSe5587.03 Cup Ø44 (35.5l)
VSe5587.04 Bush Ø68 18T
VSe5587.05 Bar Assembly
VSe5587.06 Forcing nut
VSe5587 Issue 1 27/11/19