The Handheld Programmer; Program Mode Display - Siemens SITRANS Probe LU Quick Start Manual

The handheld programmer

To activate PROGRAM mode, point the handheld programmer at the display from a maximum
distance of 600 mm (2 ft), and press the Mode key
hand-held programmer
max. 600 mm
(2 ft)
Within Program Mode, the handheld programmer has two modes of operation: Navigation and
Edit.
• Press the Mode key
the rightmost digit of the menu number flashes and the PROGRAM icon
• Press Right arrow a second time to change the mode from Navigation to Edit.
• In Edit mode, the PROGRAM icon

PROGRAM Mode Display

SITRANS Probe LU (PROFIBUS PA) continues to monitor In and Out values even when
Note:
the device is in PROGRAM mode.
3
2
1
4
When you activate PROGRAM mode for the first time in any power cycle, the LCD displays the
first menu. If, during the same power cycle, you switch to RUN mode, and then back to
PROGRAM mode, the LCD will display the menu or item that was last accessed in PROGRAM
mode.
1.
For complete instructions on local programming using the handheld programmer, please see the full
manual.
A5E32081626 SITRANS Probe LU (PROFIBUS PA) – QUICK START MANUAL Page EN-11
1
display
function
keys
to switch from RUN to PROGRAM and enter Navigation Mode:
appears and flashes.
1 – Primary region (displays parameter value)
2 – Menu number region (displays Menu number)
3 – PROGRAM mode icon
4 – Secondary region (displays text label)
.
1 2 3
5 6 7
9 0
C
4
8
numeric keys
is not visible.