Table of Contents
Advertisement
4. Touch
.
To enter the mode.
5. Timer display shows selected gas
type.
6. Touch
to set the gas type
according to table below.
0
Liquid gas G30/G31
30/30 mbar
3.5 Adjustment of minimum
level
WARNING!
Information for authorised
installer only.
Switch off the hob before the
adjustment.
To adjust the minimum level of the
burners:
1. Touch
for 3 seconds.
2. Within 7 seconds, touch
seconds.
3. Touch
4 times.
The display shows G2 mode.
4. Touch
.
To enter the mode.
5. Wait 5 seconds, after selecting the
mode.
The burner shows minimum level and the
control bar shows
6. Touch
or
.
To increase or decrease the value and
adjust the minimum level.
7. Wait 5 seconds.
To send the selected value to power
board.
8. Check it the minimum level is correct
and touch
.
To confirm the minimum level.
If the minimum level is
incorrect, repeat the steps 6
and 7.
Gas selection
1
G20 20 mbar
for 3
.
7. Touch
.
To confirm the gas type.
Touch
to exit the mode or wait for
Automatic Switch Off function activates.
Safety risk, do not use 2 gas
selection. Use only 0 or 1 gas
selections depends on gas
supply.
9. Touch
to select the next burner
and repeat the steps 5-8.
Touch
to exit the mode.
WARNING!
Make sure the flame does
not go out when you move
quickly from the maximum to
the minimum heat setting
position.
WARNING!
Do not set the G3 and G4
modes. It is for authorised
installer only.
3.6 Electrical connection
• Make sure that the rated voltage and
type of power on the rating plate
agree with the voltage and the power
of the local power supply.
• This appliance is supplied with a
mains cable. It has to be supplied with
a correct plug which can hold the load
that the rating plate rates. Make sure
that you install the plug in a correct
socket.
• Always use a correctly installed
shockproof socket.
• Make sure that there is an access to
the mains plug after the installation.
• Do not pull the mains cable to
disconnect the appliance. Always pull
the mains plug.
• There is a risk of fire when the
appliance is in connection with an
extension cable, an adapter or a
ENGLISH
9
2
Advertisement
Table of Contents
